We have a system in place but the camera angles didn’t help for total coverage. These were relatively inexpensive and easy to install with the single hole and power cords. Drilled a hole in the soffit, climbed in the attic and pulled it straight through without issues. Picture is great as well.

I’ve just finished installing all the cameras. This system replaces one I’d been using for 8 years. I thought I was happy with my old system, but this new Swann system has raised the bar on what qualifies for happiness! I’m using the default settings until I have time to digest the massive, well-written manual. The lightweight plastic camera housing let me dangle the cameras from the Cat5 connector without creating strain on that connector. A camera needs to swing freely while I attach its base to the soffit. Coincidentally, the three(3) screw holes in the base lined up perfectly with those in the old system, so I did not need to drill new holes.I needed to loosen all the camera housing screws to enable all degrees of freedom. For my installation, all the cameras are shipped “upside down”. There might be a software setting to rotate the image, but, as I said, I’ve not read the entire manual yet. I found it easiest to screw the base into place, stuff excess cable up into the soffit hole, fit the camera onto the base, fine tune alignment with those previously loosened housing screws.During installation, I used an iOS tablet running the Swann app to verify the cameras are oriented properly, then I tightened all the screws. It’s good to check with the app to see if the camera is actually connected and functioning before mounting it and tightening the screws.Using Cat5e cables already in place from the old system, I attached all cameras to the soffit sheltered by the roof eaves.I’m happy enough with this system to give it 5 stars, but I think a 5-star system should be able to sense a power outage, send an alert, shut down the hard drive, wait for restoration of power, reboot, then resume normal functions. Such a system would, indeed, be a security system. My old system couldn’t do that either, so I have to hope a UPS keeps the NVR alive and that I’m home to deal with manual shutdown, reboot, etc. I did ask about this before purchasing. The Swann rep said to use surge protection. (You can find that advice in the Q&A section of this product’s reviews.)If I remember, I’ll revisit this in a few months. I still need to test remote access from outside our home network, try the warning light and sound, set masks on image areas where PIR motion will trigger alerts.But right now, out of the box with default settings, I’m quite pleased with this system. I can sense a lot of work went into it.

Replacement for the same camera that a mouse chewed up the wiring. The old one still would’ve been working after 10 years if it was t for that.

Love the images. Very clear and audio is good too. Numerous settings that even a techie would be impressed with. Can control each camera, save and send recordings. Bought it during prime days and it’s worth every penny. Would have paid more now that I see its capabilities. Highly recommend for both residential and commercial.

Very good